Download:
iBot v1.1.8b - http://depositfiles.com/files/fs2jmahxw
iBot v1.1.8c - http://www.mediafire.com/?deas8vo6dexvxn8
Edx33 + HSServer - http://www.mediafire.com/?bk11rvfj8a225ja
Note: Please use only the above download link.

Change Log:
v1.1.8c
- Improved time synchronization of iBot with HS Server
v1.1.8b
- Added iphs.ini in iBot to set the IP for HS Server
- Added show IPHS when running HS Server
- Disable HS Server auto hide client (auto hide causes lag on some PC)

Note:
First thing you need to know about iphs.ini,
If you're running HS Server on the same PC then you don't need to set up the iphs.ini (unless it uses a different IP).
HS Server uses the ports 15777 and 15778, so if its block then you need to open those ports.

Please report errors, Thank you.

Using HS Server on different PC

Setting up:
- When you run HS Server it will display the IPHS ip... copy or remember it
- Open iphs.ini, write in the ip shown in HS Server then save it
- After all this, everytime you run iBot...it will try to connect to the specified iphs
- If done properly you should see "HS Server successfully connected!" when you run iBot

Example using 2 different PC:
- 1st PC, running HS Server
- HS Server shows IPHS: 192.168.1.2
- Press "Launch SRO" and wait till it says "Hackshield Server is now ready!"
- Hide everything including HS Server and we are all set on this PC
- 2nd PC, first is setting the iphs.ini
- open iphs.ini, type in 192.168.1.2 and save
- run iBot... if you see "HS Server successfully connected!" then you're ready to go